How to drain a combi boiler

how to drain a combi boiler

How to drain a combi boiler 

There are several reasons that you will need to drain off your homes combi boiler heating system.

It could be something like you’re leaving your property for a longer period and you don’t want to get your pipes to freeze. 

Another thing, you might want to repair, alter your pipework or radiators and want to avoid flooding your property while continuing the process. 

Also, you can flush your home heating system and reduce the chance of any unwanted sludge in your heating system.

However, it is very essential that we all should know, “You CAN NOT drain your own combi boiler until you have enough relevant knowledge on draining a combi boiler and its inner mechanisms.”

Without having correct knowledge you can not drain it safely, properly or accurately.

If you try to drain the combi boiler system without achieving adequate relevant skills, you’re likely to damage your whole heating system and ultimately it may cause severe damage in your home as well. 

 

How will you drain a combi boiler? draining heating system

It depends on the model of your appliance how you will drain your combi boiler.

Every model could be different.

So, first of all, check the manual where everything is described and follow accordingly. 

Before starting draining the water your combi boiler, make sure that you have switched off the boiler and disconnected it from the power supply. 

After that, when the hot water system is cool, locate the drain by connecting a hose securely into the drainage valve. It is usually located in the lowest point of the lowest radiator in the property.

Now open the bleed valves from all the radiators of your property. When it will be completed, the valve attached to the hose on the radiators will be opened.

You can speed up removing the process of water by opening the vents located at the top side of each of the radiators.

The bleed valve by turning will be closed after the water has fully kicked out.

At this time, if you planned for any central heating system maintenance you can start entering the system.

However, after getting the drain valve, take the topping off and all you need to do is unscrew it with a pair of pliers. You may also try to unscrew if it is loosened enough to move with your fingers.

 

Put attention on the drainage valve valve

The drainage point is situated at the endpoint from the lowest radiator of your property not the upstairs radiator.

It should be connected to the hose very securely, ideally you can use a jubilee clip.

Make sure to tighten the clip properly to avoid any unexpected leakage.

Additionally, you can place a bowl under the tightening area incase any leakage occurs, the bowl will catch the leakage water. 

Now, set the hose to the lower position of the drainage area to allow the water to kick out. Move the other end of the hose to the drainage point.

Check the valves in each of the radiators are opened, so that it will ensure your system to drain up properly. By using a wrench or a spanner, turn the square head and open the drainage valve.

Now, you will see the water is flowing out of the hose.

 

Open the vents 

You can speed up the substitute of water with air by opening the vents (bleed valves) located around your home.

When the heating system is completed from water drainage, disconnect the bleed valves, so you can start repair or maintenance according to your needs. 

 

 

A warning for you 

Draining or refilling a boiler might seem to be a straightforward task but verily when conducting this, it would be difficult for you, if you’re a novice.

So, as I already mentioned in the beginning, don’t try to drain the boiler pressure on your own, if you don’t acquire the relevant skills to drain it properly.

It will affect all your heating system in your home.

 

Final thoughts draining combi boiler

You don’t need to get worried about draining the boiler as it doesn’t require to drain often.

To get maximum efficiency you can only drain it approximately once every year.

If you start draining the boiler more regular, introduce minerals, as this will cause scaling inside the boiler.It has the probability to eventually get affected with corrosion in the boiler.

For anymore information or help please use the contact form on our contact page

Get a great price on a Which? Best Buy new boiler in minutes

Pick your install date | £0 Deposits | Pay Over 10 Years
Get a new boiler on finance with nothing (£0 deposit) to pay today 🤗Get this offer